DM75

MODEL DM75 / DM100 GUNDRILL

The DM75 Model gundrill machines have been specially designed for the North American market where accuracy, flexibility, robustness, and low cost are key customer requirements.

This machine is ideally suited for job shop or tool room applications where flexibility is paramount.

The DM75 Model gundrill machine is available in single or dual drill slide versions. Dual spindle models can be configured with a common drill slide or independently operated drill slides.

MODEL DM75 SPECIFICATIONS

Minimum drill Ø	3.0 mm	0.120 in.
Maximum drill Ø	19.1 mm	0.75 in.
Maximum drill depth	As required
Spindle type	Belt drive
Spindle power (max)	3.7 kW	5.0 Hp
Spindle rpm range	240 - 10,400
Coolant capacity	450 l	120 gal
HP pump power	5.6 kW	7.5 Hp
Maximum coolant pressure	152 bar	2,200 PSI

MODEL DM100 SPECIFICATIONS

Minimum drill Ø	6.0 mm	0.24 in.
Maximum drill Ø	25.4 mm	1.00 in.
Maximum drill depth	As required
Spindle type	Belt drive
Spindle power (max)	5.6 kW	7.5 Hp
Spindle rpm range	240 - 10,400
Coolant capacity	450 l	120 gal
HP pump power	5.6 kW	7.5 Hp
Maximum coolant pressure	152 bar	2,200 PSI

Download DM75/100 Series Brochure

To request more information or a machinery quote, click on the link above.

Tailstock Options

The DM Series gundrill machine can be equipped with a variety of tailstock configurations, depending on part type, method of load/unload, and flexibility desired.

Motor and gearbox driven counter-rotation with hydraulically actuated clamping cone part clamping.

Motor and gearbox driven counter-rotation with manual or pneumatic operated jaw chuck.

The DM75 gundrill can be configured for drilling depths to 72” or greater with traditional precision guide rails for mounting of a tailstock or with a T-slot table to utilize a variety of workpiece fixtures or a combination of both.

Tool Steadies

Special care has been taken to minimize the “lost” length. A total of 4 tool steadies can be used, each requiring only 3/4” of additional drill stroke. When no tool steadies are utilized, the lost length can be reduced to as little as 1/2”. Gundrilling of extremely long holes, up to 200 times drill diameter, is possible.